Instructions / Assembly

ManualsBrandsMonument Grills ManualsCart GrillsCharcoal Grill in Black with 2 Folding Side Shelves

Charcoal Grill

Note to Consumer

Leave this Owner’s Manual in a convenient

place for future reference.

Customer Service Helpline:

For parts ordering, call:

MFG No.: 52101

UPC No.:856597007263

Please make sure the cylinder valve

connection device shall properly and safely

mate with the connection device attached to

the inlet of the pressure regulator.

WARNING:

Read this Owner’s manual carefully and be

sure your grill is properly assembled, installed

and maintained. Failure to follow these

instructions could result in serious injury and/or

property damage. This gas grill is intended for

outdoor use only and is not intended to be

installed in or on recreational vehicles or boats.

Note to Installer

Leave this Owner’s Manual with the customer

after delivery and/or installation.

ASSEMBLY & OPERATING INSTRUCTIONS

• Parts

• Assembly

• Safety Rules

• Use and Care

1-8 - 0-9 33 00 3

Summary of content (18 pages)

PAGE 1
ASSEMBLY & OPERATING INSTRUCTIONS Charcoal Grill • Parts • Assembly • Safety Rules • Use and Care ! WARNING: Read this Owner’s manual carefully and be sure your grill is properly assembled, installed and maintained. Failure to follow these instructions could result in serious injury and/or property damage. This gas grill is intended for outdoor use only and is not intended to be installed in or on recreational vehicles or boats.
PAGE 2
Table of Contents Safety Precautions ! WARNING Warranty ---------------------------------------------- 2 Safety Precautions--------------------------------2 Hardware List --------------------------------------- 3 Parts Diagram --------------------------------------- 4 Parts List ----------------------------------------------- 5 Assembly Instructions---------------------------6~16 Cleaning and Maintenance------------------------17 Cooking Chart ------------------------------------ 18 Combustion by produc
PAGE 3
Contents for Hardware Pack The following table illustrates a breakdown of the hardware pack. It highlights what components are used in the various stages of assembly. Tools required for assembly Philips Head Screwdriver (not included). Note: The left and right sides of the grill are on your left and right as you face the front of the grill.
PAGE 4
Model 52101 Parts Diagram 4
PAGE 5
Model 52101 Parts List Seq. Material No.
PAGE 6
Assembly Instructions A34 Install Part No.12 No.13(2pcs) & No.14 with 8 A34 screws. Figure 1 A34 Step one: Install two back legs(Part No.22 No.24) onto side panels(Part No.13) with 4 A34 screws. Step Two: Install Part No.27 foot pad onto Part No. 22 with A34 screw.
PAGE 7
A34 Turn over the whole grill body as shown Step one: Install two front legs(Part No.26 No.30) onto side panels(Part No.13) with 4 A34 screws. Step Two: Install Part No.27 foot pad onto Part No. 30 with A34 screw. Figure 3 A34 Install bottom panel (Part No.29) onto four legs with 4 A34 screws.
PAGE 8
Install the wheels(Part No.23) onto right two legs (No.24 & No. 26) with wheel axle(Part No. 28) Figure 5 A32 A32 A35 A35 A35 A32 Install the air vent(Part No.6) onto side panels (No.
PAGE 9
Figure 7.1 1 Figure 7.1 Exit the bolt from the Lifting shaft(Part No.10) as pictures shown Figure 7.2 2 Figure 7.2 Assemble No.4 & No.5 onto the lifting Shaft . Fix the bolt afterward Figure 7 A34 Step two: Install whole shifting mechanism onto A34 screw Figure 8.2 Figure 8.1 Step One: Pre-install an A34 screw onto front panel by leaving 2mm space Step Three: Install and fix the second A34 screw Figure 8.3 Step Four: Fix the first Pre-install A34 screw Figure 8 9 Figure 8.
PAGE 10
A34 Install the gearing cover (No. part:15) onto the relevant place as pictures shown with two A34 screws Figure 9 Step Three: Install back the bolt Step Two: Insert the handle Step One: Exit the bolt Install the gearing handling (Part No.
PAGE 11
A35 Handy wrench needed Install the door handle(Part No.19) as pictures shown above) Figure 11 A39 Step One: Pre-install four A39 Screws onto four l Legs. Figure 12. . 1 Step Two: Put the two side Shelves onto the Screws and fix Figure 12. . 2 Figure 12. . 3 Figure 12 .
PAGE 12
A40 Install Part No.21 onto Part No.31 with 8 A40 screws Figure 13 A34 Install charcoal shelf Above(No.21 & No.
PAGE 13
A36 Install No 7 onto the main lid(Part No.3) with four A36 screws Figure 15 A38 A32 A37 A37 A35 A38 A37 A32 A38 A35 A32 Install air vent (Part No. 6) and lid handle (Part No.
PAGE 14
A36 Install the main lid onto the grill body with four A36 screws Figure 17 A33 A37 A37 A33 A37 A33 Install the handle(Part No.8) onto the ash collection pan (Part No.
PAGE 15
Figure 19.1 Place the warming rack (Part No. 11) in the relevant place Figure 19.2 Insert the ash collection tray into the grill body Figure 19 Figure 20.3 Figure 20.1 Install the temperature gauge(Part No.1 & No.2) onto the maid lid as shown Figure 20 15 Figure 20.
PAGE 16
Place the cooking grid (Part No.
PAGE 17
PREPARING TO USE YOUR GRILL SMOKING WOOD For a more robust smoke flavor while using charcoal briquettes or lump charcoal, try adding wood chips or several wood chunks to the fire. Before cooking, the following steps should be closely followed to both cure the finish and season the interior steel.
PAGE 18
COOKING RECEIPT-DIRECT HEAT 18