Operation Manual

20
English
Using Your Steam Cleaner with the Floor Brush
Step 1:
Step 2:
Step 3:
5
7
6
Locking button
Handle
8
9
10
WARNING: this appliance is under pressure. After every use, press steam trigger button
until all steam has been released before removing safety cap. Allow unit to cool for fifteen
(15) minutes before refilling.
To connect the extension tubes, press the locking button and slide the tubes in until the
opening clicks into place. (Fig. 5, Fig. 6) and press the two sections together. To
disconnect, repeat the operation by pressing the locking button and pulling the two
sections apart.Image 5: Locking button / Handle.
The floor head is supplied with a separate connection fitting. Push the connection fitting
onto the rear side of the floor head ( Fig. 7)
Insert the power cord into the outlet. Heating time is approximately 8-10 minutes with
cold water. Filling the water reservoir with hot water will shorten the heat up time.
Floor brush
Place the floor brush on top of the floor cloth and pull the cloth on each side of the brush
under the clips. (Fig. 8, 9 & 10)
Locking button