Operation Manual
19
OPERATING INSTRUCTIONS
English
4
Components:
On/Off Power Switch: The On/Off switch will light up when the unit is plugged into the 230 V
wall socket and the switch turned to the “On” position.
Steam Ready Light: The steam ready light on the handle will light up when the steam is ready
to use.
Caution: read the instructions for “Filling the Water Tank” before opening the Safety Cap.
Caution: always unplug before filling. Allow unit to cool down for 15 minutes before refilling.
Important: Do not add cleaning solutions, scented perfumes, oils or any other chemicals to the
boiler in this appliance. Use tap water or distilled/purified water if the tap water in your area is
very hard.
Filling or Refilling Your Steam Cleaner With Water
Important: always make sure the unit is unplugged from the power outlet prior to initial filling
or re-filling the water tank and has cooled down for 15 minutes. Never attempt to fill this unit
under a water tap, always use the funnel provided.
1. Before filling or refilling the steam cleaner, make sure that the unit is NOT plugged in and
has been allowed to cool for fifteen (15) minutes.
2. Press the steam trigger on the hand grip to release any residual steam from the boiler.
3. Place the unit on a flat, stable surface. Press down firmly on the safety cap and slowly turn
the safety cap counter clockwise until it is removed.
4. Place the funnel in the tank opening. (Fig. 4) Fill with a maximum of one measuring cup or
500 ml of water. Do Not Overfill. Turn the safety cap clockwise to replace.
NOTE: to remove or replace the safety cap, press down on it firmly and rotate it clockwise to
tighten or counter clock-wise to loosen. If not pressed down the cap will rotate freely without
advancing.
NOTE: filling the unit with hot water will shorten the heat up time.
5. Connect selected attachments to the Flexible Steam Hose.
6. Plug the unit into a standard (230 volt, grounded) power outlet and switch the On/Off
switch to the “On” position. Allow approximately 8-10 minutes for water to reach its working
temperature and pressure. When the unit is ready for use, the steam ready light will turn
“On”. Always point nozzle outlet in a safe direction. At the start, some water will come out
from the nozzle. This is normal. NOTE: When the steam cleaner has run out of water, steam
output will cease.
7. When finished using the unit turn off and unplug.