Installation guide

Page 9
Part No. XG0512
Rio DX Cast Stove
Installation
Wiring for the optional Blower Kit
The Rio Steel Stove may be equipped with an optional variable speed
blower kit (Part #RFK1080) for circulating additional heat into the
living space.
Installations in Canada which employ the blower kit must be electri-
cally grounded in accordance with CSA C22.1 Canadian Electrical
Code Part 1 and/or Local Codes.
Installations in the USA which employ the blower kit must be
grounded in accordance with local codes or, in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70-1987.
For more information see the Installation Guide included with the
blower kit.
Figure 26a. Wiring for optional air circulating blower kit.
NOTE: If any of the original wire supplied with the appliance is replaced, it
must be replaced with the same type, or its equivalent.
Figure 26b. Wiring schematic for optional blower kit.
1
Optional Fan Switch
Motor
Speed Control
15/1/60 Supply
G L1 L2
Wiring
2. Place the Back log onto the back log rest as shown in figure 22.
The log has a lip on the bottom which fits into the slot on the log
rest.
3. Place the Front log onto the front log rest as shown in figure 22.
Center the log from side to side, and push it against the back of
the log rest. Carefully push the log onto the metal spikes on the
log rest.
4. Place the top logs in position as shown in figure 23.
5. Start the fireplace. If the flame appears satisfactory, replace the
glass door and close the outer door.
Figure 22. Positioning for the front and back logs.
Installing the Log Set
Installing the Logs:
The Rio DX Stove is supplied with six (6) fibre logs. Unpack the logs
and handle them very carefully.
1. Remove the door cover and the glass door.
Back log
Left log
Right log
Front log
Center logs
Figure 23. Proper placement (top view).
NOTES:
 If logs are not placed properly, excessive sooting will result.
 The surface of the logs will crack due to the heat from the
flames. This is a normal occurance.