Instruction manual

STARTUP SEQUENCE:

1) Turn the wall switch ON

The combustion air switch relay will light up and the blowers

will start. Within 10 seconds the ue gas air switch will turn on.

3) The glow plugs will start to glow 45 - 60 seconds after the

pre-purge period�

4) If the pilot does not light the gas valves will turn the glow

plugs off after 20 seconds

5) This may need to be done three or four times to bleed all of the

air out of the gas lines within the replace

6) Turning the switch OFF and then ON again will reset this start

up sequence

7) Once the pilot is burning the main burner will turn on and the

replace will be functional for a quick start up on next use.

FOR YOUR SAFETY - READ BEFORE LIGHTING:

Honeywell Intermittent Pilot

■ Do not try to light any appliance.

■ Do not touch any electrical switch; do not use any phone in your

building�

■ Immediately call your gas supplier from a neighbour's phone.

Follow the gas supplier's instructions.

■ If you cannot reach your gas supplier, call the Fire Department.

C� Do not use this appliance if any part has been under water�

Immediately call a qualied service technician to inspect the

appliance and to replace any part of the control system, and

any gas control which has been under water�

A� This appliance is equipped with an ignition system that lights

the pilot burner automatically� Do not attempt to light the pilot

by hand�

B� BEFORE LIGHTING smell all around the appliance area for

gas. Be sure to smell next to the oor because some gas is

heavier than air and will settle on the oor.

What To Do If You Smell Gas:

If the information in these instructions is not followed exactly, a fire or explosion may

result causing property damage, personal injury or death.

WARNING

Operation

R720 & R820 Power Vent Indoor Gas Fireplace

Page 30

XG0772 - 100614

Operation