Instruction manual

Step 3:
Remove the trim from the bottom
of the door as shown.
Step 4:
Remove the other side, as
shown in Steps 1 - 3.
Removing the door trim:
Follow the steps below to remove, or install the R720* / R820*
replace door trim.
Step 1:
Grasp the trim on either side of the
door with the tips of your ngers.
(Both sides Typ.) Pull rmly to re-
lease the trim from the internal
door magnets.
Step 2:
Then, pull the trim from the top of
the door, as shown.
Removing the door:
Follow the steps to remove, or install the R720*/R820* replace door.
Reinstalling the door:
Follow the four previous steps to re-install the R-Series replace door.
Step 1:
Remove glass suction cups from box and place on Glass door. (The
tool may not be exactly as shown).
Step 2:
Place the suction cups on the glass door, spaced evenly. (Ensure
they are rmly attached, and secured.)
Step 3: Lifting the glass panel.
Hold the Tools rmly and lift the glass panel up and out of the lower
track (Into the upper track). Tilt the lower edge of the door panel
outwards.
Step 4:
Ensure the top edge of the glass is fully removed from the upper outer
track, and Tilt / Lift away Cautiously from the replace. Store in a safe
location until time to replace.
Section 8: Removing & Installing the Door
R720 & R820 Power Vent Indoor Gas Fireplace
Page 28
XG0772 - 100614
Installation