Specifications
1) Turn the wall switch ON
2)
The combustion air switch relay will light up and the blowers
will start. Within 10 seconds the ue gas air switch will turn on.
3)
T
he glow plugs will start to glow 45 - 60 seconds after the
pre-purge period.
4) If the pilot does not light the gas valves will turn the glow
plugs off after 20 seconds
5) This may need to be done three or four times to bleed all of the
air out of the gas lines within the replace
6) Turning the switch OFF and then ON again will reset this start
up sequence
7) Once the pilot is burning the main burner will turn on and the
replace will be functional for a quick start up on next use.
Honeywell Intermittent Pilot
■ Do not try to light any appliance.
■
D
o not touch any electrical switch; do not use any phone in your
building.
■ Immediately call your gas supplier from a neighbour's phone.
Follow the gas supplier's instructions.
■
I
f you cannot reach your gas supplier, call the Fire Department.
C.
D
o not use this appliance if any part has been under water.
Immediately call a qualied service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
A.
T
his appliance is equipped with an ignition system that lights
the pilot burner automatically. Do not attempt to light the pilot
by hand.
B.
BEFORE
LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the oor because some gas is
heavier than air and will settle on the oor.
What T
o Do If You Smell Gas:
If the information in these instructions is not followed exactly, a fire or explosion may
result causing property damage, personal injury or death.
WARNING
Page 33
XG0771 - 040513