Owner`s manual

Page 21
R520-ST & R620-ST Power Vent Indoor Gas Fireplace
Part No. XG0773 - 032211
Installation
Section 7: Removing & Installing the Door
Installation
Removing the doors:
The doors are removed in a few simple steps.
Follow the steps below to remove the Vertical Door trim, place the
Door removal tool, and then remove the door. Replace all the parts in
reverse order.
Step 1. Remove the two (2) Vertical Trim pieces, (LH & RH). Pulling
rmly with your ngers, remove from the bottom then the top. (See
Figures 17 & 17a). Other side Typical.
Figure 17. (Remove LH Trim) Figure 17a. (Remove RH Trim)
Step 2. Remove the supplied glass lifting tool from the packaging.
Place in the center of the Glass door as shown, and activate the suc-
tion feature of the tool, Figure 17b. NOTE: Read ALL the instruc-
tion supplied with the tool, and follow the associated operating
procedures.
Figure 17b. Supplied Glass lifting tools.
To install the door, follow Steps 1 and 4 above, (in reverse order).
Installing the Door:
Figure 17c. (Lift the door upward) Figure 17d. (Lift the bottom of the
door outward).
Figure 17e.
Step 3. Hold the Glass Removal Tools rmly, Lift the door upward,
into the top door frame, Figure 17c. Then pull the bottom of the glass
door downward, and tilt outward from the bottom replace door frame.
Figure 17d. NOTE: Read ALL the instruction supplied with the
tool, and follow the associated operating procedures.
Step 4. Still holding the Glass
Removal Tool rmly, remove the door
outward, and away from the Fire-
place, Figure 17e.
Step 5. Place the door in a safe
location while maintenance, cleaning
or other operation are in progress.
NOTE: Read ALL the instruction
supplied with the tool, and follow
the associated operating proce-
dures.
Step 6. To replace, See Installing
the Door, Below.
Lift Upward into
the door frame.
Lift Downward
& away from frame.
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etch-
ing may cause premature glass failure.