Owner`s manual

Page 18
R520-ST & R620-ST Power Vent Indoor Gas Fireplace
Part No. XG0773 - 032211
Installation
Blk / Wht
Brn
Gas
Valve 1
LV Wall
Switch
Gnd Green
Wht / Blk
Blk / Wht
Wht / Blk
Red
Blu
Combustion
Air Switch
Flue Gas
Switch
1 2 3 4 5 6 7 8
NC NO
Fireplace
Pre-purge
Time-On delay
Post-purge Module
WARNING! If you do not follow these instructions exactly, a re or
explosion may result causing property damage, personal injury or loss of life.
Figure 12. C-View Residential R520-ST & R620-ST Wiring Schematic
Figure 12b. Conduit and Wiring Clearances.
Conduit & Wiring clearances
Connect the wiring to the replace as outlined in the C-View Resi-
dential R520-ST & R620-ST schematic, gure 12. Connect the
wiring to the Linear power vent as outlined in the previous section.
Ensure that the proper clearances are maintained for the wiring and
conduit. When installing the wiring it must never run above the vent
run and it must be at least 1" clear of all venting.
1” Clearance