Specifications

Page 11
XG0201 Rev. 02 03/2001
M38DV-ST / ME38DV-ST Direct Vented Fireplace
Installation
Removing and Installing the
Door
Removing the door surround:
The door surround is held in place by two metal clips at the top, and
one magnet on each side. To remove the surround, pull the bottom
outwards and lift upwards until the slots "A" are clear of tabs "B" in
the door. You may need to use a flat screwdriver to pull the door
surround outwards. (See figure 18a).
Figure 18a. Removing door surround.
Removing the door:
To install/remove the glass door simply attach/remove the four (4)
machine screws, align tabs at the bottom of the door with the slots in
the bottom door rail (See figure 18b). Ensure that a good seal is
maintained.
Figure 18b. Installing Glass Door.
Glass door
and frame
Door surround
Tab 'B'
Slot 'A'
Magnet
Pull bottom of door
surround outwards
and upwards.
Machine Screws
Door Rail
Tabs
Operation
Lighting Instructions
See Pages 12-13.
Figure 19. Hi-Lo' Adjustment on the M38DV-ST / ME38DV-ST gas
valve.
Burner Adjustment
The M38DV-ST / ME38DV-ST is equipped with an adjustable burner,
allowing you to raise or lower the flames. To adjust the flames, locate
the black knob marked 'Hi-Lo', in the centre of the gas control valve
(See Figure 26). The front burners are not adjustable.
n To raise the flame height, turn the black knob (located behind the
lower trim) counterclockwise.
n To lower the flame height, turn clockwise.
Note:
M38DV-ST / ME38DV-ST models (electronic ignition) do not feature
hi/lo adjustment.