Operating instructions

P/N XG0663
Page 2
M38DV-ST/ME38DV-ST Gas Conversion Kit
Ember Burner:
3. Disconnect the 1/4" tubing from the fitting on the underside of
the pan base. Disconnect the fitting from the inlet side of the gas
control valve.
4. Spin off the coupling just above the tee. The gas valve assembly
will drop out of the way, allowing access to the coupling.
5. Unscrew the coupling assembly from the pan base. The orifice is
located at the top end of the coupling. Unscrew it and install the
orifice from this kit marked 'Ember Burner Orifice' to convert to
the new gas.
Main Gas Control Regulator:
Table Of Contents
General Information ................................................................. 2
Parts list .................................................................................... 2
A.Conversion
1. Before you begin ........................................................ 3
2. Ember Burner ............................................................. 3
3. Main Gas Regulator ................................................... 3
4. Pilot Assembly ............................................................ 3
5. Main Burner................................................................ 4
B. Check the Gas Pressure ...................................................... 4
C. Adjusting the Pilot Burner................................................... 4
Operation ................................................................................... 5
General Information
This gas conversion kit contains the necessary components for field
conversion of an approved Montigo fireplace from Natural Gas (NG)
to Liquid Propane (LP), or from LP to NG. This kit for use with the
following models:
M38DV-ST ME38DV-ST
The conversion of this appliance must conform with local codes or,
in the absence of local codes, with the American National Fuel Gas
Code, ANSI Z223.1, or the Canadian Installation Code, CAN / CGA
Parts List
Quantity Description
2 Sleeves (main burner)
1 Pilot burner orifice
1 Ember burner orifice
1 Main burner orifice
1 Label for rating plate indicating conversion
1 Label for gas control valve indicating conversion
CAUTION - Before you begin:
1. Shut off gas at the shut-off valve and disconnect the electrical
supply (if used).
2. Remove the glass door as shown in the installation instruc-
tions
and remove the logs. Flip down the lower trims to access the
A. Conversion
Figure 1b. Changing the ember burner orifice.
Figure 1a. Accessing the ember burner orifice.
WARNING!
This conversion kit shall be installed by a qualified service
agency in accordance with the manufacturer's instructions
and all applicable codes and requirements of the authority
having jurisdiction. If the information in these instructions
is not followed exactly, a fire, explosion or production of
carbon monoxide may result causing property damage,
personal injury or loss of life. The qualified service agency
is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation
of the converted appliance is checked as specified in the
manufacturer's instructions supplied with this kit.
Gas Conversion Instructions