Specifications



15. Set the High-Low Regulator to desired setting:
Turn fully counterclockwise for High and fully
clockwise for Low. If using a Thermostat, keep
on High setting.
NOTE: An odor, resulting from the initial heating
of new materials in your heater, is not unusual
during the rst re, and in most cases will disap-
pear after an hour or two.

1. If using optional thermostat, set thermostat to
the lowest position.
2. Turn off the electric power to the blower.
3. Turn the ON-OFF switch on the upper right
rear of the stove to the OFF position.
4. Push in the gas control knob slightly and turn it
clockwise to “OFF.”
NOTE: The knob cannot be turned from “PILOT”
to “OFF” unless it is pushed in slightly. Do not
force it.

The ame height adjuster can be accessed by
opening the right side panel. Turn the adjuster clock-
wise to increase ame height and counterclockwise
to decrease. See above left. Adjusting the ames too
high will cause them to have black tips and cause
sooting. Sooting can cause the glass to get dirty.
Check ame height after ve to ten minutes and
readjust if necessary.

If pilot ames are less than shown at left, use
pilot adjuster shown below, to increase ames.
Flame Height
Adjuster
Normal Flame pattern. Note: Flames will vary in height
and position depending on the placement and the amount of
ember wool.
Warning: The unit and
adjuster may be hot.
Wear gloves and arm
protection if making
adjustments while in
operation.
Pilot Adjuster