Specifications
Remove the air grill by pulling forward.
Lift the latch shown above and tilt the glass door
out at the top and lift off the hooks at the bottom.
Handle the glass with care.
Replacing the Gasket
The Conquest uses part no. 3-44-00539 ber-
glass gasket in the front door. Should it ever need
replacement, use only the proper replacement gasket
that is available from your Harman dealer. Replace
the gasket as follows:
1. Lay glass door face down on a soft surface that
will not scratch the glass.
2. Remove the nuts holding the top and bottom
glass clip in place.
3. Remove glass from door and remove old gasket.
4. Install new gasket around glass.
5. Place glass back in door.
6. Reinstall glass clips and tighten the nuts.
7. Reinstall glass door by placing the slots on the
bottom of the door over the hooks on the bottom
of the door opening. Next, lift the latch and push
the door against the unit. Pull the spring loaded
latch front until the tab drops into the slot on the
door frame.
8. Reinstall air grill.
The glass may be cleaned with ordinary house-
hold glass cleaner and a soft cloth or paper towel.
WARNING: Never clean the glass when it is
A qualied service person should conduct an
annual inspection and maintenance of your Conquest,
its venting, and the installation to keep it running
safely and efciently. The following procedures
should be performed only by a qualied service per-
son. The gas supply should be turned off whenever
a maintenance procedure is performed.
If the glass door or side doors are removed for
servicing, they must be replaced prior to operating
the stove.
with the glass front removed, cracked, or
broken. Replacement of glass should be done
by a licensed or qualified service person.
Never use substitute materials.
Latch
Air Grill
Gold Frame
Door
Glass
Gasket
Top
Clip
Bottom
Clip