Specifications



Only For Qualied Installers

If the optional thermostat is used, it must
be plugged into the TH terminals located on the
valve.
When installing a millivolt control system, use
only a special low resistance thermostat. DO NOT
USE A REGULAR HEATING THERMOSTAT.
Be sure that all electrical connections are clean,
free from corrosion, and tight. Inspect connections
periodically to conrm that no corrosion has built
up over time.
When properly installed and maintained, a
millivolt control system should give many years of
trouble-free service.
It is important to use wire of a gauge proper for
the length of the wire:
RECOMMENDED WIRE GAUGES
Maximum Wire
Length Gauge
100’ 14
60’ 16
40’ 18
25’ 20
15’ 22
Thermostat

The button on the remote control can be used
to turn the re on and off.
This remote uses the ultrasonic control method
and does not need to be pointed directly at the re-
place.
The kit includes installation instructions, a hand
held sending unit, receiving unit, mounting bracket,
and all wiring.
Note: The ON/OFF switch must be “OFF” when
using the remote or a thermostat. If the switch is in
the “ON” position, the re will stay on even when
the set temperature on the thermostat is reached.
Glass Grill
To install the glass grill remove the door and
slide the top of the vertical bars up into the slots at
the top of the rebox opening. Lower the grill down
so the bottom of the vertical bars rest just inside the
lip at the bottom of the rebox opening.
Reinstall door.
Burner Button
Glass Grill