Operating instructions

ManualsBrandsMontigo ManualsLawn and GardenM38DV-PFC

 Check local codes and

read all instructions

prior to installation.

 Leave this manual with

the owner.

M38DV-PFC

Conversion Kit

Warning: If the information in these instructions is not followed

exactly, a ﬁre or explosion may result causing property damage,

personal injury or loss of life.

Do not store or use gasoline or other ammable vapors and liquids in the

vicinity of this or any other appliance.

 What To Do If You Smell Gas:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas

supplier's instructions.

• If you cannot rea

ch your gas supplier, call the re department.

Installation and service must be performed by a qualiﬁed installer, service agency or

the gas supplier.

RCV025

Conversion to LP

RCV125

Conversion to Natural Gas

Summary of content (6 pages)

PAGE 1
M38DV-PFC Conversion Kit RCV025 Conversion to LP RCV125 Conversion to Natural Gas Warning: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the    • • • • vicinity of this or any other appliance. What To Do If You Smell Gas: Do not try to light any appliance.
PAGE 2
M38DV-PFC Conversion Kit Table Of Contents Gas Conversion Instructions General Information.................................................................. 2 A. Conversion Parts list..................................................................................... 2 A.Conversion CAUTION - Before you begin: 1. Before you begin......................................................... 3 2. Ember Burner.............................................................. 3 3. Main Gas Regulator.............
PAGE 3
M38DV-PFC Conversion Kit Gas Conversion Instructions Main Burner 10. Remove cover plate on both ends of the main (center) burner and remove main burner tube. (See figure 5) 11. Loosen the set screws at each end of the burner tube. Slide the sleeves out of each end of the tube and replace them with the ones from the package marked 'Main Burner Sleeves' in this kit. (See Inset, Figure 6.) Re-tighten the set screws. 16. Replace the logs, re-install the door and the door surround. 17. The label (part no.
PAGE 4
M38DV-PFC Conversion Kit Gas Conversion Instructions Checking the Gas Pressure Main Gas Control Regulator: 9. The SIT Hi/Lo gas control valve supplied with this appliance has a removable regulator. To replace it, remove the three screws as shown in Figure 6, and install the new regulator supplied with this kit. remove screws to replace regulator To check the Inlet and Manifold gas pressures, a Water Column Pressure Gauge with 5/16" dia. tubing can be used.
PAGE 5
M38DV-PFC Conversion Kit Operating Instructions For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas.
PAGE 6
XG0652 Rev. 00 - 12/00 Canadian Heating Products Inc. Montigo Del Ray Corp.