Owner`s manual

Page 10
L52DF Flush Indoor Gas Fireplace
Part No. XG0185 - 092109
f i r e f e a t u r e
Installation
Figure 15. Straight, vertical venting showing required PXT-10 adaptor
(supplied with the PVTK-1 termination).
* For venting MIN 1" clearance to all vertical combustibles,
MIN 2" to all horizontal combustibles.
Figure 17. Vertical venting with 2 osets (1 oset= two 90° bends).
Figure 16. Vertical venting with 1 oset (1 oset= two 90° bends).
PEXT
PEXT
PXT-10
1 MIN
1 MIN
1 MIN. Both
sides Typical
RHS8 Heat
Shield
Figure 16a. RHS8 Installation. (Install by sliding over vent pipe where
it passes through the combustible construction.
Figure 16b. RHS101 Installation. (Install by sliding over vent pipe where
it passes through the combustible construction.
Framing
Drywall
RHS101 Heat Shield,
Inner Section.
Vent from fireplace
RHS101 Heat Shield,
Outer Section.
Termination
32’