Owner`s manual

Page 16
L42DF Flush Indoor Gas Fireplace
Part No. XG0181 - 081009
f i r e f e a t u r e
Installation
Figure 29. Installation of glass beads .
Installing the Glass Beads and
Optional River Rocks
Beads
The L42DF is supplied with Designer Glass beads. Remove the Door
and trim as shown in the previous Instruction. Follow these instruc-
tions to ensure all parts are removed or replaced as required.
Once the Trim and glass doors are removed place the marbles ran-
domly across the pan surrounding the burners as shown in Figure 29.
NOTE: DO NOT Cover burners with beads or the optional rocks, as
shown in Figure 29.
Note: Ensure the rocks or beads do not cover the Burners
Optional River Rocks
The L42DF has the option of installing the optional cultured rocks
which mimic real stone. They are attrative yet designed to withstand a
hightemperatureenvironmentsuchasinsideagasreplace.These
may be spaced at random, or in a visual pattern of your preference.
See the Montigo web site for photographs and ideas.
www.montigo.com
Note: Ensure the rocks or beads do not cover the Burners.
2
Step 5:
Ensurethetoolisrmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
Step 8:
Grasp the Door on either side, usually midway and lift upward, lift
thedoorcarefullyupandawayfromthefrontofthereplace.See
gures 28g. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
3
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
4
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Removing the Door:
Figure 28d.
Figure 28e.
Figure 28f.
Figure 28g. Removing and installing the glass doors. (Both Sides
Typical)
To install the door, hook the top edge of the door frame into place.
Lower the door into position and follow the previous steps shown in
reverse order.
Installing the Door:
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etching
may cause premature glass failure.
Donotoperatethisreplacewithouttheglassdoor,orwitha
broken glass door.