Owner`s manual


L42DF* Indoor Gas Fireplace
XG0181 - 112811.1
Installation
 Combustible Framing Side Heat Shield , (two 2-pcs).

Included with the  Gas replace, is a framing heat shield Kit. This
Kit is fabricated from galvanized steel and arrives with three (3) pieces,
as shown below. The shields protect all adjacent combustible materials,
mantels and mouldings from excessive heat radiated by the replace.
 The shields must be installed as shown in Figures 9 9b.
. Fasten the two Side shield's () rst, and ensure they
are fastened in place as shown. These are installed with the Wide anges
facing the center of the replace opening, and the shallow ange toward
inside of room. These are also fastened with nails or screws, ush with
framing as shown in Figure 9 and Inset.
 Combustible Framing Top Heat Shield , (one 1-pc).
 Combustible Framing Heat Shield, completed.
. Next, fasten the Top shield (), with the Wide ange
face up, and the shallow ange toward inside of room, Figure 9a.
Nail or screw the top shield in place ush with framing, as shown
in gure 9b.
fireplace
framing
fasteners,
3-per. side
Both Side
shields typical
flush with
framing
INSET
Section
fireplace
framing
Top shield
fasteners,
3-pcs.
INSET
Section
flush with
framing