Owner`s manual


L42DF* Indoor Gas Fireplace
XG0181 -112811.1
Installation


The  door is removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
Door buckle locations.
Removing and installing the Horizontal Access Panel


Remove the Horizontal cover
by placing ngers in both nger
holes, then pushing away from
you and lifting out. Place it aside
during maintenance or cleaning.
Install in reverse order.
To install the door, hook the top edge of the door frame into place. Lower
the door into position and follow the previous steps shown in reverse order.
Installing the Door:
2

Ensure the tool is rmly in
the lower end of the slot,
(as shown), Then pull toward
you (Caution: hold the tool
securely).
3

Pull hard if necessary to
release the spring tension.
(Caution: The latch springs
back with force, hold the tool
securely).
4

Remove the tool from the
latch slot. Ensure the latches
are hanging freely, the hook
end is released from the
bottom of the door. (Repeat
all 4-steps for the remaining
latches).



Step 8:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the replace. See
Figures 26g. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Removing and installing the glass doors.

Door Latch Hook
Door Latch Slot
Hand-hold

. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)

Step 3:
Finger Holes
Installed Gas
Valve Cove
r