Owner`s manual


L42DF* Indoor Gas Fireplace
XG0181 - 112811.1
Installation

The  hasan to modify theIncoming air. This will
ensure the ame is as per the design criteria. See Figures 22 & 22a.
. Closed Vane for Top Vent Fireplaces.
. Open Vane for Rear Vent Fireplaces.
 which employ the fans must be grounded in
accordance with local codes or, in the absence of local codes, with the
National Electrical Code, 
For more information see the  included with
the fan kit.
NOTE:
If any of the original wire supplied with the appliance is replaced,
it must be replaced with the same type, or its equivalent.
 Wiring diagram for optional fans.
G
L2-WH
L1-BLK
p g
Quick Connect
lu to motor
5/1/60 Supply
G L1 L2
optional
All  replaces may be equipped with optional fan kits for circulating
heat into the living space.
  which employ the fans must be electrically
grounded in accordance with   Canadian Electrical Code
Part 1 and/or Local Codes.

The  gas valve may be connected to a wall switch. Do 
connect any external power to the remote switch. The valve will
generate its own power on a millivolt circuit or will draw its power from
an AC Connection inside the replace, depending on the model of the
unit. Use only low voltage wire, and connect any external
power to the remote switch.
Refer to for wiring requirements.
 The switch location must not exceed 30' from the replace.