Owner`s manual


XG0147 - 011912.1

Installation

The is supplied with ve ceramic bre logs. Unpack the logs
and handle them very carefully.
 Remove the glass door as described in the previous Instructions
 The base log is factory-installed.
 Arrange the ember chips on top of the burner tray. Care should be
taken when placing the ember chips, as blocked burner ports may
cause an incorrect ame pattern, carbon deposits and delayed
ignition. Also, the chips must never be placed in a way that obstructs
any of the air inlet ports, located at the rear of the burner, as shown
in .
 Place the top right log as shown below in gure 29c. Align
the tab on the underside of the log, far right end, with the pro-
vided notch in the bottom right log, Figure 29b.
 Bottom left & right log placements.
 Top right log placement.
 Completed log placement.










 Log mounting base, placement locations.
All ceramic bre Logs have been designed to enable quick and easy
placement. Please follow the instruction below.

 Place the bottom left and right logs as shown above in
gure 29a.


Rest the top log in the provided notch on top of the Top right
log, gure 29c.
Place the left end of the log as shown below in gure 29d

Top Left Log
 Back Left log placement.
 Place the back left log on top of the bottom left log, while
resting the right side of the log on the mounting tray. As shown in
gure 29b.
 Ember placement, (ll voids between front logs and along the front
of the grate / pan).
If logs are not placed properly, excessive sooting will result.
NOTICE