Owner`s manual



XG0147 - 011912.1



Installation

 Corner installation. (NG Models Only)

 Flex installation. (NG Models Only)

 

Attach an PEL-45 (45° elbow) directly onto the ue collar. Cut the

PXT-20 to suit, and attach it to the PEL-45. Slide the replace into

position and attach to the termination.

 

Use an PTO-4 termination and an PFL-1 or PFL-2/PFL-2 (12" or 24"

compressed length) and a frame, if appropriate.Flex may be turned

to obtain desired degree of angle required but must not exceed 45°.

 

The Kit includes a heat

shield, a PFL-12 (f/f) exible pipe, and a termination with or without

a mounting frame.

PEL-45 Elbow

PEL-90 Elbow

PXT-18

Heat Shield