Owner`s manual
Page 16
HW-Series Gas Fireplace
Part No. XG0190 - 071409
Installation
Log 'D'
Cautions:
■ If logs are not placed properly, excessive sooting
will result.
■ The surface of the logs will crack due to the heat from
theames.Thisisanormaloccurrence.
Installing the Log Set
Installing the Logs:
The HW38-DF issuppliedwithveceramicbrelogs.Unpackthelogs
and handle them very carefully.
3. Place the top right log as shown below in figure 29d. Align the
tab on the underside of the log, far right end, with the provided
notch in the bottom right log, Figure 29c.
Figure 29b. Bottom left & right log placements.
Figure 29d. Top right log placement.
Figure 29e. Completed log placement.
Base Log
Log Base
Bottom Left Log
Bottom Right Log
Back Left Log
Mounting Tray
Bottom Right Log
Mounting Tray
Bottom Left Log
Mounting Tray
Figure 29a. Log mounting base, placement locations.
Figure 29c. Back Left log placement.
AllceramicbreLogshavebeendesignedtoenablequickandeasy
placement. Please follow the instruction below.
Back Left Log
1. Place the bottom left and right logs as shown above in figure
29b.
2. Place the back left log on top of the bottom left log, while resting
the right side of the log on the mounting tray. As shown in figure
29c.
Notch
Notch
4. Rest the top log in the provided notch on top of the Top right log,
figure 29d.
5. Place the left end of the log as shown below in figure 29e.
Top Left Log
Top Left Log
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etching
may cause premature glass failure.
Donotoperatethisreplacewithouttheglassdoor,orwitha
broken glass door.










