Owner`s manual

Page 9
H(L)38DF-PRC Indoor Panorama Gas Fireplace
Part No. XG0211 - 080510
Installation
Figure 11c. Rear vent, Roof mounted venting (1 = 90° bend).
Section 3-2-2: VENTING COMPONENTS
Select from the following components and associated Montigo
part numbers for installation of a Roof Mounted Termination.
Use only Montigo Vent Components. Use of non-Montigo parts
will void the warranty and may impede operation of the replace.
Connection and installation of the vent components should
adhere to the following guidelines:
 Use any combination of rigid and Flex pipe as required.
 Flex sections may be stretched up to 50% of their total length
(e.g. a 24” section maybe stretched to 36”).
 Connect all vent sections using a minimum of three sheet
metal screws on the outer pipe ue.
 Ensure the pipe ends male to female slide in a minimum of
1 1/2” of overlap.
 Ensure all runs are supported with a minimum of 3 supports
per 10’ of venting.
 When hanging/ supporting venting, ensure that 1” clearance
is maintained on sides and bottom of vent runs and 2” above
horizontal vent runs to any combustible material.
 Ensure when cutting sections of rigid pipe to maintain integrity
of internal supports.
 Place the springs, supplied with the pipe kit, between the
outer and inner pipes to keep the pipes separate and avoid
any possible hot spots.
 Montigo recommends the use of a ex section for the nal pipe
connected directly to the replace offering greater exibility of
installation and absorption of movement.
 When penetrating a combustible ceiling, a ceiling restop
must be used.
 Montigo recommends that all exterior corners and joints be
sealed with exterior caulking however we encourage you to
consult your Building Envelope Engineer or Waterproong
Consultant for further recommendations.
A- Termination PVTK-1
D - Support Ring
& Plate
PSPXT- 8
E - Firestop PS- 8
F - Roof Flashing PRF- 7 (1/12 - 7/12 pt.)
PRF-12 (7/12 - 12/12 pt.)
B - Flex Sections PFL- 1 (12" f/f Section)
PFL- 2 (24" f/f Section)
PFL- 3 (36" f/f Section)
PFL- 4 (48" f/f Section)
C - Rigid Sections
PEXT- 1 (12" m/f Section)
PXT- 20 (20" f/f Section)
PEXT- 2 (24" m/f Section)
PEXT- 3 (36" m/f Section)
PEXT- 4 (48" m/f Section)
PFL- 18 (18" f/f Section)
PFL- 6 (72" f/f Section)
PXT- 5 (5" f/f Section)
PXT-10 (10" f/f Section)
PEXT- 6 (72" m/f Section)
Support ring
Support plate
32’ max
PVTK1
Termination