Owner`s manual

H*38DF PRC Panorama Indoor Gas Fireplace
Page 21
XG0211 - 040912.1
Installation
Section 7: Installing & Removing the Door
Removing the door:
The H*38PR* doors are removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
Figure 24a. Locate the door buckles.
Figure 24. Removing and installing the Horizontal Access Panel
Locate the Door Buckles:
Step 2:
Step 1:
Remove the Horizontal cover
by placing ngers in both nger
holes, then pushing away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Install in reverse order.
Remove the Horizontal Access Panel:
To install the door, hook the top edge of the door frame into place. Lower
the door into position and follow the previous steps shown in reverse order.
Installing the Door:
2
Step 5:
Ensure the tool is rmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
3
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
4
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 24d.
Figure 24e.
Figure 24f.
Step 8:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the replace. See
Figures 24g. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Figure 24g. Removing and installing the glass door.
Removing the Door:
Door buckles
Fixed
panel
Fixed
panel
Door Latch Hook
Door Latch Slot
Hand-hold
Release the Door Buckles
Figure 24b. Door buckle Tool
1
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 24c.
Step 3:
Finger Holes
Installed Gas
Valve Cove
r