Specifications

ManualsBrandsMontigo ManualsLawn and Garden36DRG

Page 1 of 11

36DRG

09/96

INSTALLATION, OPERATION AND MAINTENANCE MANUAL

MODEL 36DRG

PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLING AND OPERATING THE FIREPLACE

THE DELRAY MODEL 36 DRG INSERT IS C.G.A. APPROVED FOR NATURAL GAS AND PROPANE

ALWAYS RETAIN THE MANUAL WITH THE UNIT IN THE EVENT OF A CHANGE OF OWNERSHIP

APPROVED AS A GRAVITY VENTED ROOM HEATER

FOR YOUR SAFETY:

IF YOU SMELL GAS:

1.) OPEN WINDOWS DO NOT STORE OR USE ANY

2.) DO NOT TOUCH ELECTRICAL SWITCHES FLAMMABLE VAPOURS OR LIQUIDS

3.) EXTINGUISH ANY OPEN FLAME NEAR THIS OR ANY OTHER GAS-

4.) IMMEDIATELY CALL YOUR GAS SUPPLIER BURNING APPLIANCE.

FOR INSTALLATION IN ACCORDANCE WITH CANADIAN REQUIREMENTS

CERTIFIED TO STANDARD: CAN/CGA 2.22 - M86 VENTED DECORATIVE APPLIANCE

CAN/CGA 2.17 - M91 HIGH ALTITUDE

CAN/CGA 2.1 - M86 ROOM HEATER

CANADIAN HEATING PRODUCTS INC

13120 - 76TH AVENUE, SURREY B.C. V3W 2V6

PHONE (604) 597-3115 FAX: (604) 597-3096

Summary of content (11 pages)

PAGE 1
INSTALLATION, OPERATION AND MAINTENANCE MANUAL MODEL 36DRG PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLING AND OPERATING THE FIREPLACE THE DELRAY MODEL 36 DRG INSERT IS C.G.A. APPROVED FOR NATURAL GAS AND PROPANE ALWAYS RETAIN THE MANUAL WITH THE UNIT IN THE EVENT OF A CHANGE OF OWNERSHIP APPROVED AS A GRAVITY VENTED ROOM HEATER FOR YOUR SAFETY: IF YOU SMELL GAS: 1.) 2.) 3.) 4.
PAGE 2
GENERAL INSTRUCTIONS NOTE: All gas inspection authorities in Canada require that the installation and maintenance of heaters and accessories shall be accomplished by qualified gas fitters in accordance with the CAN/CGA B149.1 and 2 installation codes and other applicable code requirements specified by the authorities having jurisdiction.
PAGE 3
./ NATURAL GAS AND PROPANE PIPING A.) All gas piping shall be in accordance with the current CAN/CGA B149.1 and .2 installation codes and installed by a qualified professional gas fitter technician. Inlet pressure N/G 7.0 W.C. Minimum natural gas inlet pressure 5.0" W.C. Manifold pressure 3.5" W.C.
PAGE 4
5./ INSERT INSTALLATION This appliance is to be installed in a masonary or slid fuel fireplace only. (Not for use with air tight units.) *Ensure that the plastic protective coating on the all brass pieces is removed before lighting the fireplace. Failure to do so will result in permanent damage to the brass. Outer Shell The brass louvres can be easily removed from the outer box of the fireplace. We recommend that they are removed to prevent any damage. The louvres are held on with spring loaded pins. 1.
PAGE 5
RHEOSTAT CONNECTION (FAN SWITCH) AUTOMATIC HEAT CONTROL (100 F) 2 AMP FUSE 8.) Push the drafthood back in to place and re-secure. BK BK BK VARIABLE SPEED CONTROL WH STRAIN RELIEF BK G JUNCTION BOX QUICK CONNECT PLUG TO MOTOR BLOWER BLOWER MOTOR DRAWING #5 9.) Level the unit by adjusting the two hex head machine screws located inside the shell. For easiest access, adjust these screws prior to replacing the heat exchanger.
PAGE 6
13.) a) Operating the fan: The fan speed can be controlled by turning the variable speed control clockwise to slow the fan down and counterclockwise to speed it up. There is a built-in automatic heat control that will Activate when the fireplace has reached (100 F) temperature. The fan will not operate when the fireplace is cold. b)Removing fan assembly for servicing: Remove the (3) screws located on each side wing of the fan bracket. Remove the (3) screws located on the base of the bracket.
PAGE 7
6./ OPERATION "For safety, this appliance has been equipped with a high limit switch. In the event of over heating, this switch will automatically turn the unit down to pilot. Upon cooling, the main burner will re-light. If this switch is activated, call a qualified service person to inspect the fireplace." A./ TESTING, ADJUSTING AND CHECKING BURNER AND CONTROLS Light burner by carefully following instructions for starting given in this manual.
PAGE 8
CLEANING PROCEDURE {GLASS AND BURNER COMPARTMENT} Periodic cleaning of the glass will be necessary. Frequency of cleaning will depend on fireplace usage. a.) Turn the control knob to the “OFF” position. This will extinguish the flame and allow the unit to cool. DO NOT ATTEMPT TO CLEAN THE FIREPLACE WHEN IT IS HOT! b.) Carefully remove glass pieces. Use caution as glass edges may be sharp NOTE: IN CASE OF BROKEN GLASS, REPLACEMENT GLASS MUST BE SUPPLIED BY CANADIAN HEATING PRODUCTS INC.
PAGE 9
FOR YOUR SAFETY: IF YOU SMELL GAS, OPEN WINDOWS - DON'T TOUCH ELECTRICAL SWITCHES, EXTINGUISH ANY OPEN FLAME - IMMEDIATELY CALL YOUR GAS SUPPLIER. NOTE: THIS GUIDE IS MERELY A MEANS OF IDENTIFYING THE PROBLEM AND ITS PROBABLE CAUSE. REPAIRS SHOULD BE DONE BY A QUALIFIED SERVICE PERSON. ALL PARTS ARE AVAILABLE FROM CANADIAN HEATING PRODUCTS INC. OR YOUR LOCAL DEALER/DISTRIBUTOR.
PAGE 10
DELRAY GASFIRE 36 DRG SPARE PARTS 11. 10. 9. 16. Pilot Burner Assembly 11. 8. 12. 6. 7. 5. 1. 2. 14. 4. 2. 3. 13. 15. PARTS DESCRIPTION 1. 2. 3. 4. 5. 6. 7. 8. 09/96 Gas Control Valve 48FF-6 Connector Union 90 degree Steet Elbow Compression Nut 1621410 3500125C CH-1 Compression Spring 3/4" ID Flat Washer Silicon Sponge Seal 9. 10. 11. 12. 13. 14. 15. 16.
PAGE 11
DELRAY GASFIRE 36DRG GAS FIREPLACE WARRANTY THE WARRANTY The Companies warrants the Montigo Gas Appliance to be free from defects in materials and workmanship at the time of manufacture. On the Montigo, there is a ten-year warranty on the firebox and its components, a five-year warranty on the main burner, pilot burner and a one-year warranty on the gas control valve and glass doors.