Instructions / Assembly

INSTRUCTION MANUAL
5
RAISE AND RELEASE DRAWER FRONTS
These units are equipped with raise and release
drawer fronts. To open, lift up on the drawer front while
pulling towards you. To close, shut the drawer rmly
until the latch engages.
If the drawer does not stay closed, the hook may be
bent, or it may be rubbing against the drawer slides. To
x this problem, lightly bend the hook until the drawer
will engage in the slide.
Lift
DRAWER REMOVAL
Pull the drawer out so that it’s almost fully extended.
Push up on the black release lever on one side, while
pulling down on the black release lever on the other
side. While holding the levers in these positions, pull
the drawer outward until it is released from the drawer
slide.
ONE SIDE – PUSH UP
OTHER SIDE – PUSH DOWN
DRAWER REPLACEMENT
Extend the drawer slides from the unit. Insert the
brackets on each side of the drawer into the slots
in the slides, being careful that they are properly
positioned. Once properly inserted, completely close
the drawer to set the slides in position.
MAINTENANCE
Lubricate the casters with high quality bearing grease
(annually/yearly).
Lubricate the slides (twice a year) with a product like
WD40 or other quality lubricant. This is especially true
as the temperature decreases, which can cause the
bearing to become stiff.
Periodically clean the drawer fronts, drawer
trim, and other surfaces with mild detergent
and water.