Installation Sheet

ManualsBrandsMonte Carlo ManualsCeiling Fans4 Speed Hand-held Smart Remote Control with Wall Holster

SAFETY INFORMATION AND GENERAL GUIDE

READ AND SAVE THESE INSTRUCTIONS

• Please read and understand this entire manual before attempting to assemble, install or operate

the product.

• Make sure that all electrical connections comply with local codes, ordinances, the National

Electrical Code and ANSI/NFPA 70. Hire a qualified electrician or consult a do-it-yourself wiring

handbook if you are unfamiliar with installing electrical wiring.

Warning

: Before proceeding, be sure to shut off electricity at main switch or circuit breaker in

order to avoid electrical shock.

MCSMRC REMOTE CONTROLLER

INSTALLATION AND OPERATION INSTRUCTION

Note: Fan installation must be complete including assembly of blades before testing the

remote controller.

Note: Refer to your Ceiling fan instruction manual for Safety and installation instruction.

Warning: This remote controller is for use on ceiling fans and fan lights only.

Warning: Do not exceed maximum rating of the remote controller. Install the wall mount

cradle away from excess heat or humidity

Customer Service

800-969-3347

Customer Service Center

7400 Linder Ave.

Skokie, IL 60077

www.montecarlofans.com

Summary of content (6 pages)

PAGE 1
MCSMRC REMOTE CONTROLLER INSTALLATION AND OPERATION INSTRUCTION SAFETY INFORMATION AND GENERAL GUIDE READ AND SAVE THESE INSTRUCTIONS • Please read and understand this entire manual before attempting to assemble, install or operate the product. • Make sure that all electrical connections comply with local codes, ordinances, the National Electrical Code and ANSI/NFPA 70. Hire a qualified electrician or consult a do-it-yourself wiring handbook if you are unfamiliar with installing electrical wiring.
PAGE 2
Warning: Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. Use AC 120V/60HZ power supply only. Refer to the fan installation instruction manual Receiver For fans that have been installed with a remote controller, remove the canopy and disconnect lead wires.
PAGE 3
Remote Controller Operation Remove the battery cover from the remote control transmitter and install batteries. Replace the cover. This remote uses 2 1.5V/AAA batteries. Note: If not using for long periods of time, remove the batteries to prevent damage to remote controller, and store the remote controller away from excess heat or humidity. The batteries will weaken with age and should be replaced before they leak or corrode as this will damage the controller. Dispose of the used batteries properly.
PAGE 4
Install Transmitter wall mount cradle with 2 screws provided. Useful tips: The remote transmitter can be removed by pressing it upward from the lower half. The remote transmitter can be held on magnetic metal materials by a magnet built in the transmitter. Wall mount cradle User Tips 1. If your fan is operating automatically after installation, it is still using the factory setting. Follow the settings for Learn Mode above to reset. 2.
PAGE 5
Fan operation with Bond Home APP Download the Bond Home app with your smart devices. The app is available on the Google Play Store and Apple Store. Or get it from bond home link, http://bondhome.io/app Create a new account following on-screen operating steps. Make the fan (Smart by Bond wi-fi receiver) connection with wi-fi router.
PAGE 6
Jul.2021 Nov.