Installation Guide

9/25/2013

REMOTE CONTROL SETTING and OPERATION

Press the button to get desired fan speed, Low to High and then High to Low

cyclically.

Press the OFF button to turn fan off. Fan speed will maintain last setting if

turned off.

Press this forward/reverse button to get desired airﬂow direction. Fan must be

running to reverse. It will take about 25 seconds for fan to slow down and

change rotation direction.

Up/Down light control button. Press this button quickly to turn light on or off.

To dim light, hold down the button, the light will cycle from bright to dim to

bright until button is released when the receiver is set at “DIM” position. Light

will maintain last setting if turned off.

Note

: Dimming function is not available if the dimming (DIM) and non dimming

(ON/OFF) switch in receiver is set at ON/OFF position.

Note

: Not all items include all the functions, refer to function chart on the page

Note

: Make sure the fan is set on HIGH speed and the light is in the ON

position by pull chain controls originally supplied with your fan.

Useful tips

LED indicator against fan speeds, Fan off, Low speed,

Medium speed, Medium high speed and High speed.

Fig. 9

The buttons on the remote control transmitter control the fan speed and light

as follows. (Fig. 9)

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES OPERATION IS SUBJECT TO THE FOLLOWING TWO

CONDITIONS. (1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT

ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.