Installation Sheet

Loosen the set screw. Remove the
hanger ball and pin on the downrod in fan
package. Keep parts.
Install the new hanger ball and the pin
onto the downrod.
Warning: Make sure the pin is installed
well on hanger ball with downrod. Tighten
the set screw securely.
Refer to the fan installation
instruction manual for fan, safety
cable installing and wiring.
Place downrod over canopy, canopy
bottom cap and yoke cover (Not all fans
include yoke cover).
Thread lead wires and safety cable from
motor assembly through downrod.
Pin
Hanger ball
Setscrew
Pin
New hanger ball
Setscrew
Slip downrod into motor housing yoke,
aligning holes and install cross pin and keeper
pin.
Insert cross pin through yoke and downrod
until point appears on the other side, and
insert keeper pin on cross pin.
Pull the downrod up tight against the cross
pin, and then evenly tighten the downrod set
screws on motor housing yoke.
Place Yoke cover on motor assembly.
Warning: Cross pin and keeper pin must be
installed securely, failure to install them will
result in serious injury.
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning: Failure to align slot on ball with
tab may result in serious injury.
Important: If using the angle mount,
make sure open end of mounting bracket
is installed facing the higher point of the
ceiling and make sure the ceiling angle is
not steeper than 45º. Longer downrod
may be necessary allowing the fan blades
to rotate without obstructions.
Align the locking slots of the canopy with
the two screws and alignment on the
bottom of the mounting bracket. Push up
the canopy and turn clockwise until the
alignment post engage to the round hole
and the screws engage to the
key slots. Tighten the set screws
securely.
Break off the tab of the canopy bottom
cap.
Peel the backing off the adhesive tape
strips on the inside of the decorative
cover ring. Secure to the canopy by
gently pressing the adhesive tape to the
bottom of the canopy.
Cnopy bottom cap
Canopy
Downrod
Yoke cover
Outlet box
Ceiling
Ceiling peak
Hnager ball
Mounting
Bracket
Tab
Retaining
Ball Slot
Canopy
screws
Canopy
Canopy bottom
cap
Canopy bottom cap
Downrod
Alignment
Tab
Keeper pin
Cross pin
Downrod
Downrod
5
3
4/2021
© 2021 Monte Carlo Fan Collections
8 9 10
6 7