Installation Sheet

OFF

Before you begin handling parts

replacement, Switch power off at Service

panel and lock service disconnecting

means to prevent power from being

switched on accidentally. When the

service disconnecting means cannot be

locked, securely fasten a warning device,

such as a tag, to the service panel.

Unpacking the Kit and make sure all the

components included.

1. Mounting bracket with 2 canopy

screws.

2.Canopy

3. Hanger ball

4. Canopy bottom cap

Partially loosen preinstalled set screws

from mounting bracket and remove the

canopy from the mounting bracket.

Before installing this fan make sure the outlet box is properly installed to the house structure. To reduce the risk of ﬁre, electric

shock, or personal injury, mount to outlet box or supporting system acceptable for fan support.

(Mounting must support at least 35 lbs)

Use metal outlet box suitable for fan support and use only the screws provided with the outlet box (must support 35 lbs). Before

attaching fan to outlet box, ensure the outlet box is securely fastened by at least two points to a structural ceiling member ( a

loose box will cause the fan to wobble). Remove the two outlet box screws provided with the box, aligning the holes of the

mounting bracket with the holes of the outlet box. Reinstall the 2 outlet box screws securely.

Important: If the fan or fan with light is over 35lbs ( kg), The outlet box and support structure must be securely mounted and

capable of reliably supporting 50 lbs (22. 7 kg). Use only UL Listed outlet boxes marked "Acceptable for Fan Support of 50 lbs

(22. 7 kg) or less."

Important: If using the angle mount, make sure open end of mounting bracket is installed facing the higher point of the ceiling and

make sure the ceiling angle is not steeper than 45º. Longer downrod may be necessary allowing the fan blades to rotate without

obstructions.

Mounting bracket

4/2021

2 3