Installation Guide

TROUBLESHOOTING

1. Check blue wire from fan to make sure it is connected to hot wire from house.

2. Check for loose or disconnected wires in fan switch housing.

3. Check for loose or disconnected wires in light kit.

4. Check for faulty light bulbs.

WARNING: Over lamping the fan/light kit will result in the

fan/light kit lights shutting down until the proper wattage of bulbs

are installed. Reset the lights by turning off the wall switch, breaker,or by

remote. Replace bulbs with the correct wattage bulbs, turn the power on.

CAUTION: Make sure main power is turned off before entering switch housing.

Customer Service Center:

301 West Washington St.

Riverside, NJ 08075

1-800-519-4092