Installation Guide

Install the switch housing cover with light
kit to the fan by screwing the three side
mount screws.
13
Semi Flush Ceiling Mount (if so equipped)
Install 2 longer screws to mounting
bar. Install to the 2 inside holes on
the bar. These will match to the ceil-
ing canopy
.
1
Install mounting bar to outlet box in
the ceiling using screws provided.
Mak
e sure that the heads of the
screws installed in the previous step
are facing into the outlet box.
2
Locate blue and white wire from the fan
marked “for light kit”. Connect blue from fan to
black from light kit and white from fan to white
from light kit by pushing connectors together.
Note: If your fan does not have plugs they may
be cut as shown on figure “B” on page 2.
12
Cut plugs from ends of leads as in figure B
on page 2. Thread wires from fitter through
nut, spacer, nut, and extension then tighten
them to fitter
. Now add the sleev
e to co
ver
the nuts, spacer, and entension.
3
extension
spacer
nuts
sleeve
10
Install glass bowl using rubber wash-
er and nut provided.
Install cage to glass using finial nut.
Make sure to align hole in fitter with
hole in glass and cage for fan speed
pull chain.
1
1