Installation Guide

Remove the plug from the center of
the switch housing by unscrewing or
pushing out. This plug will no longer
be needed.
Tighen keeper nut onto threaded
pipe from the light kit.
Remove the switch housing cover
from the fan by unscrewing the three
side mount screws.
1
2
8
6
Install switch housing to light kit by
turning clockwise to tighten.
Install keeper nut over lead wires.
7
GENERAL INSTALLATION
Thread wires from light kit through
center hole in switch housing.
5
s
witch
housing
c
over
Tread wires from light kit through
center hole in reflector plate.
3
4
Install reflector plate to light kit by
turning clockwise to tighten.
9
Install 3 x 60 watt candelabra bulbs. Bulbs
included.
WARNING: Over lamping the
fan/light kit will result in the
fan/light kit lights shutting down
until the proper wattage of bulbs
are installed. Reset the lights by turn-
ing off the wall switch, breaker,or by
remote. Replace bulbs with the correct
wattage bulbs, turn the power on.