Installation Guide

Install chain to loops at fixture and
ceiling canopy and close using chain
pliers. Tighten retainer nut.

Make wire connection to power source in the
outlet box. Use wire nuts to make the following
connections. Connect black from fixture to
black from power source. Connect white from
fixture to white from power source. Connect
bare ground wire from fixture to ground wire
from outlet box., Make sure all wire filiments
are inside the wire nuts. After wire nuts are
installed push connections into outlet box with
wire nuts pointing upward.

Unscrew canopy retainer nut from
upper chain loop. Place canopy over
the chain as shown.

Install fixture assembly to the
mounting strap by inserting lamp
cord and ground strap through the
threaded pipe on mounting strap.
Turn chain loop clockwise.

Using chain pliers open chain link at
one end, determine hanging height
and open a chain link to achieve
height needed.

Install cap and chain loop as shown.

Thead wires through chain. Be sure
to leave enough wire to make wiring
connections at the powe source.

Install chain to loops at fixture and
ceiling canopy and close using chain
pliers.

canopy
retainer
nut