Installation Guide

Remove the plug from the center of
the switch housing by unscrewing or
pushing out. This plug will no longer
be needed.
Tighen keeper nut onto threaded
pipe from the light kit.
Remove the switch housing cover
from the fan by unscrewing the three
side mount screws.




Install 4 x 40 watt candelabra torpedo shape
bulbs. Bulbs included. # 9(5
/$03,1*7+()$1/,*+7.,7:,//5(68/7
,17+()$1/,*+7.,7/,*+766+877,1*
'2:1817,/7+(3523(5:$77$*(2)
%8/%6$5(,167$//(' (6(77+(/,*+76
%<7851,1*2))7+(:$//6:,7&+
%5($.(525%<5(027((3/$&(%8/%6
:,7+7+(&255(&7:$77$*(%8/%678517+(
32:(521
Install finial cap and glass to fitter
body. Align hole in fitter, glass, and
finial cap to allow the fan speed pull
chain to pass through. Install finial
nut and tighten.


Install switch housing to light kit by
turning clockwise to tighten.
Install shades as shown.

Install keeper nut over lead wires.

GENERAL INSTALLATION
Thread wires from light kit through
center hole in switch housing.

s
witch
housing
cover