Installation Guide

2
© 2015 Monte Carlo Fan Company
6/25/2015
Wall Transmitter Installation, Wiring and Setting
White AC IN N
Green
ON
OFF
120 VAC SUPPLY
Green from
Black To Hot
Black AC IN L
Black To Fan
Wall transmitter
ON/OFF Switch
Outlet Box
Figure 1
O
N
OFF
ON
Figure 2
Figure 3
O
N
O
FF
ON
Warning: Before proceeding, be sure to shut off electricity
at main switch or circuit breaker in order to avoid electrical
shock.
Note: Before installing the wall transmitter, place it in OFF
position by pushing ON/OFF switch to the OFF.
Make series-wound connection for the wall transmitter with
HOT wire from house. Connect a black wire (Marked AC IN L)
from wall transmitter to the HOT wire and then connect the
other wire (Marked To Motor L) of wall transmitter to the
LOAD wire in outlet box (Follow the marks shown on the
labels on the lead wires from wall transmitter).
Connect green grounded wire to grounded wire from outlet
box. (Fig. 1)
Install the wall transmitter to outlet box using machine
screws provided. Attach wall plate to wall control unit with
screws provided. (Fig. 2)
Note: Place the wall transmitter in ON mode when fan
installation is completed.
ON
OFF
DIP Switches
UPPER
LOWER
Universal Mode and Learning Mode
Remove switch cover by finger or using a small pointed object as shown
in figure 3. If wall plate has been installed, remove it so as to pry the
switch cover open.
There are “Universal Mode” and “Learning Mode” with the remote
controller.
If choosing “Universal Mode”, simply place both dip (code) switch at
UPPER position. Your fan with the remote controller is ready to use. (Fig.
3)
Note: If using universal mode, your fan can be controlled with other
remote transmitters with the same setting.
To control the fan with specific remote transmitter, choose “Learning
Mode” by placing the dip (code) switch at LOWER position and then make
learn function setting as below.
Make “Learn function setting”, Restore power source to your fan, press
and hold the “SET” button for about 4 seconds until buzzer inside receiver
sounds. Your remote controller is ready to operate the fan. You must
press the “SET” button within 1 minute of restoring power to the fan.
(Fig.3)
Note: If the power is on already, you must turn the power off for at least
5 seconds and then turn the power back. Wait for 6 seconds at least
then make learn function setting. If the fan is running after turn power
back, still wait for at least 6 seconds and then press and hold the “SET”
button for about 4 seconds until buzzer inside receiver sounds. Your
remote controller is ready to operate the fan.
Note: If you want to control a fan with 2 transmitters (Wall mount or
hand-held transmitter.
2 Wall mount transmitters are not available if
they are wired with the fan in parallel
), turn the power off for at least 5
seconds and then turn the power back and wait for at least 6 seconds
for learn function setting. Setting for both transmitters must be done
within 1 minute of restoring power to the fan. A fan can be controlled by 2
transmitters maximum when choose Learning Mode.
Black from fan (Receiver)
White from Fan (Receiver)
OFF ON
OFF ON
Open End
Switches
Cover
Set code switch
SET