Installation Guide

3/8/2013

Light bulbs and glass installation

Install 3 x 60 watt candelabra base bulbs, Bulbs included.

WARNING: Over lamping the fan will result in the fan lights

shutting down until the proper wattage of bulbs are installed.

Reset the lights by turning off the wall switch, breaker,or by

remote. Replace bulbs with the correct wattage bulbs, turn

the power on.

Caution: Do not replace bulb until it cools down.

Partially unscrewing the thumb screws on the glass holder,

insert the glass, then tighten the thumb screws evenly. DO

NOT OVER TIGHTEN THE THUMB SCREWS. (Fig. 13)

Install fan pull chain and light kit pull chain to preassembled

pull chains on fan and light ﬁxture. Pull chains provided.

(Fig. 13)

Forward/Reverse switch setting

Setting the reverse switch in the down position will result in

downward airﬂow and setting the switch in the up position

will result in upward airﬂow.

Note: Reverse switch must be set either completely down

or completely up for fan to function. If the reverse switch is

set in the middle position, fan will not operate. (Fig. 14)

Operation and Maintenance

Refer to operation and maintenance on the second page of

parts list.

Fig. 13

Reverse switch

Glass

Light ﬁxture

Thumb screws

Bulbs

Fig.14

Pull chains