Installation Guide

3/8/2013

Installation Instruction (Downrod Mount)

Partially loosen downrod set screws from yoke at top of motor

assembly.

Remove keeper pin and cross pin from yoke, and save for later use.

Place downrod over canopy, thread lead wires and safety cable from

motor assembly through downrod.

Slip downrod into motor housing yoke, aligning holes and install cross

pin and keeper pin.

Insert cross pin through yoke and downrod until point appears on the

other side, and insert keeper pin on cross pin.

Pull the downrod up tight against the cross pin, and then evenly tighten

the downrod set screws on motor housing yoke. (Fig. 3)

Warning: Cross pin and keeper pin must be installed securely, failure

to install them will result in serious injury.

Install ball end of downrod into mounting bracket opening. Align

(engage) slot on ball with tab on mounting bracket.

Warning: Failure to align slot on ball with tab may result in serious

injury. (Fig. 4)

Canopy

Downrod

Lead wires and

Safety cable

Motor assembly

Set screw

Cross pin

Keeper

Fig. 3

Fig. 4

Yoke

Downrod

Tab

Slot