Instructions / Assembly

4
© 2017 Monte Carlo Fan Company
09/2017
7 8 9
10 11 12
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning: Failure to align slot on ball with
tab may result in serious injury.
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod mode the safety
cable must be installed into the house
structure beams using 3” lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
Make wiring connections using wire
connectors provided as indicated above.
Connect Black wire from fan to Black
(Hot) wire from house. Connect White
wire from Fan to White (Neutral) wire from
house. Connect all green grounded wires
to Grounded wire from House. Make sure
that no filaments are outside of the wire
connectors.
Partially loosen 2 of the set screws on
mounting bracket corresponding to the
slotted holes on the canopy upper ring.
Remove the other 2 set screws. Save
screws.
Raise canopy to mounting bracket,
aligning loosened screws in mounting
bracket with slotted holes in canopy.
Twist canopy to lock. Reinstall screws
that were previously removed and then
tighten all screw securely.
Install blades on flywheel with set screws
provided.
Note: Flywheel is located on top side of
styroforam.
Note: Be sure to use the set screws in
the pack marked Step 11.
Note: Make sure the side with a label
“This side for blade installation” is
installed upward.
Note: Put blades on carpet to avoid
blade damage from scratch.
Note: The preassembled setscrews are
for installation of the blade assembly in
step 13.
Flip the blade assembly over and install
blade supporting ring onto the blades
with screws provided.
Note: Blade supporting ring is located on
top side of styrfoam.
Note: Make sure the side with a label
“This side up” is installed upward.
SAFETY CABLE INSTALLATION
Lag screw
Safety cable
Washer
Lock washer
Tab
Slot
Power supply
Black
white Grounding/Green
Black
Wall switch
Flywheel
Blade
This side for
blade installation
Preassembled
Preassembled
setscrews
This side up
UP
Blade supporting ring