Instructions / Assembly

5
© 2014 Monte Carlo Fan Company
12/2017
13 14 15
16 17 18
Install blade assembly with screws
provided, aligning each of the holes as
shown and tighten all screws securely.
Repeat this process for remaining blades.
Lift light pan up, thread the light lead
wires and the safety cable with clamp
through the slot in light pan as shown.
Note: Keep the safety cable with clamp
outside the slot, so it will be easier for
blanking plate installation in the step 20.
Attach light pan onto the plate on motor,
aligning the keyhole slots on the light pan
with the preassembled screws on the
plate. Twist clockwise till lock. Reinstall
the screw removed in step 14. Tighten all
screws securely.
Remove 3 set screws from side of light
pan. Keep screws
Connect white wire from fan to white wire
from LED light kit and then connect blue
(or black) wire from fan to blue (or black)
wire from LED light kit.
Note: If you don’t want to install the
fan with LED light, go to step 20 for
blanking plate installation.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save screw
for later use.
Install LED Light Kit
LED light kit
Light pan
Blade assembly
Plate on motor
Safety cable with clamp
Safety cable with clamp
Light lead
wires