Instructions / Assembly

3
© 2014 Monte Carlo Fan Company
12/2017
1 2 3
4 5
ON
OFF
ON
OFF
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Use AC 120V/60HZ power supply
only.
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 35 lbs.)
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 35 lbs).
Before attaching fan to outlet box, ensure
the outlet box is securely fastened by at
least two points to a structural ceiling
member ( a loose box will cause the fan to
wobble). Remove the two outlet box
screws provided with the box, aligning
the holes of the mounting plate with the
holes of the outlet box. Reinstall the 2
outlet box screws securely.
Hang motor assembly onto the buckle on
mounting plate for hands-free wiring and
safety cable installation.
Clasp the cable with hook into the buckle on
mounting plate as shown in inset.
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 1.5” lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
Make wiring connections using wire
connectors provided as indicated above.
White from house to White from remote
receiver marked AC IN N. Black from
house to Black from remote marked AC
IN L. Connect all green grounded wires to
Grounded wire from House. Make sure
that no filaments are outside of the wire
connector.
Connect plug from receiver to plug from
fan. Be sure plugs connection clasp
together firmly.
Mounting plate
6
Black
White
Wall switch
Black (Live)
White (Neutral)
Green/Ground
Receiver
Cable with hook
Buckle on mounting
plate
Lag
screw
Safety
cable
Washer
Lock washer