Installation Guide

12/30/2011
© 2011 Monte Carlo Fan Company
4
Install 3 screws and washers per
blade and tighten securely. Repeat
for all 5 blades
14
Check the motor for plastic shipping
stabilizer tabs, and remove them if
they are present.
15
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
10
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
11
House
Fan
Black
White
Green
Black
White
Green(downrod)
Green(Bracket)
Blue
For control of fan and optional light
from wall location, follow diagram
above. NOTE: A professional electri-
cian is recommended for this type of
installation.
12
Light Switch
Fan Switch
Wall
Control
Loosen one and remove one pre-
assembled screw from mounting
bracket. Save screw. Lift canopy up,
aligning its keyhole slot with the pre-
assembled screw on mounting
bracket and twist clockwise to lock in
place. Re-install the removed screw
and tighten all screws securely.
13
Attach blade assembly to motor using
the motor screws and washers provid-
ed. Tighten screws securely.
Setting the reverse switch in the
down position will result in down-
ward airflow and setting the switch
in the up position will result in
upward airflow.
16
Reverse
switch