Installation Guide

© 2011 Monte Carlo Fan Company
1/16/2012
4
Place blade onto blade holder.
14
Install 3 screws and washers per blade and
tighten securely. Repeat for all 5 blades
15
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
a
re outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
t
he outlet box and ungrounded conductor on the
other side of the outlet box.
10
For pullchain controls, follow diagram above.
M
ake sure that all exposed wiring is secured in-
side wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
j
unction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
11
House
Fan
Black
W
hite
G
reen
Black
White
G
reen(downrod)
G
reen(Bracket)
B
lue
For control of fan and optional light from wall lo-
cation, follow diagram above. NOTE: A profes-
sional electrician is recommended for this type
of installation.
12
Raise the canopy up and align the two holes in
the canopy with the two holes in the hanger
bracket. Secure with two screws provided.
13
Light Switch
Fan Switch
Wall
Control
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present. At-
tach blade assembly to motor using the motor
screws and washers provided. Tighten screws
securely.
16
Push wires through center hole.Line up 2 screws
loosened from step 17.
18
Remove 1 screw and save.Loosen other 2
screws.
17
Remove
and save
this screw.