Installation Sheet

6
© 2021 Monte Carlo Fan Collections
5/2021
Remote Controller Operation
Remove the battery cover from the remote control transmitter and install batteries.
Replace the cover. This remote uses 2 1.5V/AAA batteries.
Note: If not using for long periods of time, remove battery to prevent damage to remote
transmitter, and store the remote transmitter away from excess heat or humidity.
The battery will be weaken with age and should be replaced before leaking takes place
as this will damage the transmitter. Dispose of the used battery properly and keep the
battery out of the reach of children.
Dimming, Non Dimming Setting (Only available for fans with light)
In the dimming mold, it is a light dimming selection and it is to be used with dimmable
luminaries. The remote controller is set with dimming function at factory.
In ON/OFF (non-dimming mold), it is for light ON/OFF only (non-dimming function).
The buttons on the remote control transmitter control the fan speed and light as follows.
Fan speed
1 = low speed 2 = medium speed 3 = medium high speed
4 = high speed
This button turns the fan off.
Light button- Press this button to turn light on or off.
Light button- Press this button to desired brightness, dim to bright.
Light button- Press this button to desired brightness, bright to dim.
Breeze-
Press the Breeze button, the Fan will operate randomly among 1
st
- 4
th
speed until the breeze mode is
canceled.
Breeze mold can be erase by pressing the buttons of power or speed control.
Note : This remote controller has auto resume function, the fan and light will maintain the last setting if
turned off with exception of the Breeze mold.
Battery cover
DIM (D)
ON/OFF (O)
SET
SET
1
0
1
0
1
0
Universal Mode and Learning Mode
There are “Universal Mode” and “Learning Mode” (marks “0” and “1”) with the remote controller.
If choosing “Universal Mode”, simply place dip (code) switch at LOWER position (mark “0”). Your fan with
the remote controller is ready to use.
Note: If using universal mode, your fan can be controlled with other remote transmitters with the same
setting.
To control the fan with specific remote transmitter, choose “Learning Mode” by placing the dip (code)
switch at UPPER (mark “1”) position and then make learn function setting as below.
Learn Function Setting
Important: Only turn the power on for the fan which you would pair with the transmitter and make sure to
turn the power off for all other fans which use the same remote controller.
Restore power to your fan, press and hold the “SET” button to pair the Transmitter and receiver. You must
press the ‘SET” button within 60 seconds of restoring power to the fan.
Note: Fan will operate at minimum speed and light will blinks (If the fan with light) after the setting.
Note : If the power is on already, you must turn the power off then turn the power back for remote control
setting.
Note : If reset the dip switch to “0” position (universal mold). It has to be paired again, run the learn function
setting.