Installation Sheet

5
12 13 14
15 16
© 2021 Monte Carlo Fan Collections
5/2021
Install blade bracket with blade by using
blade set screws and fiber washers
provided. Tighten screws securely.
Repeat this process for remaining blades.
Connect the light lead wires from fan to
LED light fixture with a quick connector
as shown in the illustration.
Note: Be sure quick connector clasped
together completely.
Install the LED light fixture onto the hub
on the fan.
Place light lead wires in the hub and
attach LED light fixture onto the hub by
locating ridges in the LED light fixture
with the grooves on the hub and twist
clockwise until tight
Caution: Make sure the lead wires are
placed in the hub and keep them from
damage.
Setting the reverse switch in the down
position will result in downward airflow
and setting the switch in the up position
will result in upward airflow.
Note: Reverse switch must be set either
completely down or completely up for fan
to function. If the reverse switch is set in
the middle position, fan will not operate.
Install the blade assembly to motor using
the preinstalled screws. Tighten screws
securely. Repeat this process for
remaining blade assemblies.
LED light
fixture
Hub
Reverse switch
Yoke cover
Blade
Blade bracket
Fiber washer
Blade screw