Installation Guide

© 2011 Monte Carlo Fan Company
5/5/2012
3
Before you begin installing the fan, Switch power off
at Service panel and lock service disconnecting means
to prevent power from being switched on accidentally.
When the service disconnecting means cannot be
locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
1
Remove Safety bar from mounting bracket by
loosing screws, sliding bar to side, and lifting it
off the 2 screws.
3
Warning-Risk of fire, electric shock, or personal
injury. The fan in this box may be either directly sup-
ported from a structural framing member of a build-
ing and/or may be mounted to an outlet box marked
acceptable for fan support of of 31.8 kg(70lbs) or
less. Most outlet boxes commonly used for the sup-
port of lumminaires may not be acceptable for fan
support and may need to be replaced. Consult a
qualified electrician if in doubt.
2
OUTLET BOX METHOD
Remove the 6 screws attaching the Mounting
neck the mounting plate. Retain the 6 screws
for re-assembly.
4
Remove keeper from pin and then
remove pin. Replace keeper in pin
and save.
9
Lift mounting neck to mounting Plate
and align screws.
7
Secure mounting neck to the mount-
ing plate with 6 screws to become
a complete mounting bracket.
8
Secure mounting plate directly to a joist from
the buliding structure via the two knock out
holes on the outlet box. Use only the appropri-
ate wood screws and washers included with
your fan.
Caution: Wood screws must go through into
the building joist.
Note:If Installing It In The U.S., Do Not Re-
move Knockouts In The Outlet Box
5
Outlet box
Mounting
Plate
Wood
Screws
BUILDING STRUCTURE METHOD
Install the mounting Plate to approved fan
brace and box combination use only the hard-
ware provided with the fan brace and box.
6
FAN BRACE AND OUTLET BOX METHOD
For Installation in The U.S. only