Instructions / Assembly

5
© 2013 Monte Carlo Fan Company
11/5/2013
13 14 15
16 17 18
Align the holes of blade bracket, blade
and the medallion of blade holder.
Install blade bracket with blade by 4
blade screws provided. Tighten screws
securely. Repeat this process for
remaining blades.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Attach light pan onto the plate on motor,
aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screw removed in step 15.
Tighten all screws securely.
Loosen 2 and remove 1 preassembled
screw from light pan. Save screw for later
use.
Remove finial, final cap, hex nut and
silicon washer from light fixture. Keep
parts.
Connect white wire from fan to white wire
from LED light kit and then connect blue
wire from fan to black wire from LED
light kit.
Attach LED light kit onto the light pan,
aligning the keyhole slots on the LED light
kit with the preassembled screws on the
light pan. Twist clockwise till lock.
Reinstall the screw removed in step 17.
Tighten all screws securely.
Remove shipping stabilizers from motor
assembly.
Insert blade assembly into the slot on
flywheel.
Install blade assembly with screws
provided, aligning each of the holes as
shown and tighten all screws securely.
Repeat this process for remaining blades.
Note: Make sure the side with blade arm
medallion is installed downward.
Blade
Blade bracket
Blade arm medallion
Blade assembly
Shipping
stabilizer
Light pan
Light fixture
Silicon washer
Hex nut
Final cap
Finial
Light pan
Light fixture