Installation Guide

5
11 12 13
14 15
16
© 2021 Monte Carlo Fan Collections
1/2021
Blade
Lift Canopy allowing the 2 studs to protrude
through the canopy.
Install knurled nuts as shown. Tighten the
knurled nuts securely. The canopy should
adjust for any irregularity in the ceiling or
Outlet box.
Make sure the studs protruding from the
bottom of the Mounting bracket are installed
with threads all the way through the bracket.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Insert blade into the slot on flywheel.
Install blade with screws and fiber
washers provided, aligning each of the
holes as shown and tighten all screws
securely. Repeat this process for
remaining blades.
Attach light pan onto the plate on motor,
Place light pan over the lead wires from
fan, aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screw removed in step 13.
Tighten all screws securely.
Loosen 2 and remove 1 preassembled
screw from light pan. Save screw for later
use.
Connect white wire from fan to white wire
from LED light kit and then connect blue
(or black) wire from fan to black (or blue)
wire from LED light fixture.
Attach LED light fixture onto the light pan,
aligning the keyhole slots on the light
fixture with the preassembled screws on
the light pan and twist clockwise till lock.
Reinstall the screw removed in step 15.
Tighten all screws securely.
Light pan
Stud
Plate on motor
White
White
Blue
Black
Light pan