Instructions / Assembly

7
© 2015 Monte Carlo Fan Company
10/20/2015
24
25
27 28
26
29
Install 3 x 60 watt candelabra base bulbs,
Bulbs included. WARNING: Over lamping
the fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed. Reset the lights by turning
off the wall switch, breaker,or by remote.
Replace bulbs with the correct wattage
bulbs, turn the power on.
Caution: Do not replace bulb until it
cools down.
Remove finial, final cap, hex nut and
rubber washer from light fixture. Keep the
parts.
Align hole in center of final cap with thread
rod, allowing pull chains to come through
appropriate holes in the final cap, and push
up. Thread center pull chain through hole in
finial and secure glass to light fixture by
tightening the finial. DO NOT OVER TIGHTEN
the finial as glass may crack or break.
Setting the reverse switch in the left hand
side will result in downward airflow and
setting the switch in the right hand side
will result in upward airflow.
Note: Reverse switch must be set either
way completely. If the reverse switch is
set in the middle position, fan will not
operate.
Install fan and light kit pull chains to
preassembled pull chains on fan. Pull
chains provided.
Raise glass in order to guide pull chains
through appropriate holes in glass, aligning
threaded rod on light fixture with hole in
middle of the glass and push up gently
allowing threaded rod to come through
hole. (Note: Be sure pull chain for fan
operation does not rub against bulb during
operation).
Install the rubber washer and hex nut to
hold the glass. DO NOT OVER TIGHTEN IT.
Bulb
Final cap
Finial
Rubber washer
Hex nut
Glass
Reverse switch